Now as a general observation the Pico isn't the only board that has a CDC problem with Win7/8.1!! I have 2 different "sense" boards which should work with arduino, the manufacturers say that the boards work with win7.but does win7/8.1 give them a com port? Not a chance! But I am wondering if something similar to the above Pico fix could work with the other boards. So the big question is there a fix for RP2 Boot? Or can that error be ignored? USB Mass Storage Device (tick)Ready to use But as the Pico now has a com port on win7 I reckon it will work with arduino! Upon Driver Booster installed the WD SES USB device driver for you, you can check if the WD external hard drive can be detected by the. Locate Disk drives and then Update the WD SES USB Device driver. Driver Booster will start scanning for all your device drivers on Windows 10. Now I don't know if the pico will talk to Thonny on win7 as I was trying to get the pico to work with my win8.1 laptop and I haven't installed Thonny on my Win7 laptop (Mu is a non starter). Download, install and run Driver Booster. Yep it worked for me as well (I'd already installed micropython (the only version that didn't have unstable in the file name) using a Pi-zero and VNC). ***The following is for my Win7 laptop*** Right click on the CDC Device and update or install driver choosing the file you created from the location you saved it at. A yellow exclamation mark indicates it.Ĩ. Go to your pc device list, find the pico under Ports, named something like CDC Device. Close and save and make sure your retain the name as pico-serial.infħ.
0 Comments
Leave a Reply. |